News center
Your present position:Home >> News Center
The bottom of the enamel equipment requirements
Addtime：2016-11-10 10:14:29 Print
Our company is a well-known supplier of enamel equipment, make a brief introduction of the bottom of the enamel equipment requirements.
The quality of the enamel equipment, first of all depends on the tire iron.Without high quality iron and is impossible to have the high quality of the enamel equipment.To ensure the quality of products, tire iron should satisfy the following six requirements:
(1) bottom tire surface should be smooth, and may not be a significant tool scars, pits, mezzanine and other mechanical defects;
(2) on the surface of the bottom tire bead to straight, neat, weld width shall not exceed the steel plate, thickness of 1.5 times.Weld joint want to smooth the transition, there is no slag inclusion, porosity, bite edge, such as lack of penetration defects;
(3) bottom weld on the surface of the tire to be polished before sand blasting;
(4) the amount of butt weld in the wrong side of the tire surface at the bottom to the thickness of less than 10%;
(5) 0.15% less than the diameter of the flange roughness;
(6) pressure surface to ensure that the design of the mating flanges under the pressure of seal.
If you have any need, welcome to contact us, we will sincerely service for you.
The quality of the enamel equipment, first of all depends on the tire iron.Without high quality iron and is impossible to have the high quality of the enamel equipment.To ensure the quality of products, tire iron should satisfy the following six requirements:
(1) bottom tire surface should be smooth, and may not be a significant tool scars, pits, mezzanine and other mechanical defects;
(2) on the surface of the bottom tire bead to straight, neat, weld width shall not exceed the steel plate, thickness of 1.5 times.Weld joint want to smooth the transition, there is no slag inclusion, porosity, bite edge, such as lack of penetration defects;
(3) bottom weld on the surface of the tire to be polished before sand blasting;
(4) the amount of butt weld in the wrong side of the tire surface at the bottom to the thickness of less than 10%;
(5) 0.15% less than the diameter of the flange roughness;
(6) pressure surface to ensure that the design of the mating flanges under the pressure of seal.
If you have any need, welcome to contact us, we will sincerely service for you.